Electricians & Plumbers in Dallas, GA

I began by safely shutting off the water supply to the water heater. I then replaced the faulty thermal expansion tank and drain valve, ensuring all new components were correctly installed. After reactivating the water supply, I meticulously inspected all connections for any signs of leaks. No leaks were detected, confirming the successful repair. The water heater was tested to ensure it was operating efficiently. Finally, I cleaned up the tools and materials, leaving the work area neat and tidy.

Electrician is installing a new emt circuit

Electrician, giving a free electrical estimate for a panel replacement

Electrician is installing a grounding system for a pool pump

Arrived on site to assess the customer’s plumbing concerns and provide an estimate. Performed an inspection of the kitchen drain system and determined that the kitchen sink drain piping requires replacement. Also measured and evaluated approximately 12 feet of existing 3-inch drain pipe that is recommended for replacement due to its condition. Discussed the scope of work with the customer, including the proposed materials, installation process, and expected results. Provided a detailed quote for repiping the kitchen sink drain and replacing 12 feet of 3-inch drain pipe. Answered all customer questions and reviewed the recommended repairs.

Installed a new hose bib and upgraded the faucet to improve outdoor water access and performance. Ensured all connections were secure, leak-free, and up to code. Tested both fixtures for proper flow and functionality. Customer now has reliable water service for exterior use and improved indoor fixture performance.

Removed a faulty hose adaptor that was causing a steady leak and water loss. After safely disconnecting the adaptor, inspected the connection for damage, cleaned the threads, and ensured a proper seal to restore normal function. System was tested and confirmed leak-free with proper pressure.

Replaced existing 50-gallon gas water heater and installed a Halo 5 whole-house water filtration system. Filled and pressurized both systems, then turned the water on and thoroughly inspected all connections for leaks. No leaks were found, and all equipment is operating properly. After confirming proper operation, cleaned the work area and removed all job-related debris. While filling and testing the systems, it was discovered that the septic tank is backed up and will require further evaluation and service.

Electrician completing lighting project

Completed a plumbing service installing a new hose spigot connected to the home?s filtration system. Ensured proper tie-in for clean, filtered water access while maintaining strong flow and secure, leak-free connections. All work was completed to code and tested for reliability.

Replaced a faulty American Standard shower valve to restore proper water flow and temperature control. Shut off water to the home and safely removed the existing valve and trim. Cut into the wall as needed to access plumbing and disconnected the old valve. Installed new American Standard shower valve, ensuring proper alignment, secure connections, and compatibility with existing water lines. Soldered and/or connected fittings as required and installed new trim kit. Turned water back on and thoroughly tested for leaks, proper pressure, and smooth hot/cold operation. Confirmed valve is functioning correctly with no leaks. Cleaned up work area and ensured customer satisfaction.

Completed a shower valve replacement today. The old valve was worn out and causing issues with temperature control and water flow. Shut off the water, removed the existing valve, and installed a new shower valve to restore proper operation. Tested the system after installation to ensure there were no leaks and that both hot and cold water were mixing correctly. The shower is now working properly with consistent water pressure and temperature control. Another plumbing repair completed and the customer is back up and running.