Electricians & Plumbers in Rocky Face, GA

Electrician completing panel replacement

Completed a comprehensive electrical safety inspection of the property. Inspected the main electrical panel, breakers, wiring, outlets, switches, and visible electrical connections for signs of damage, overheating, loose connections, or other safety concerns. Tested accessible outlets and electrical components for proper operation and verified the panel and circuits were functioning as expected. Documented any items requiring attention and left the electrical system in safe working order.

Electrician installing floor outlets

Completed installation of a new water service line from the city meter to the home. Once installed, the water was turned on and the new service was inspected for proper flow and leaks. After confirming everything was functioning properly, the work area was cleaned and left in good condition.

Arrived on site and installed a new water service line from the city meter to the house. After completing all connections, allowed the glue to cure properly before turning the water back on. Pressurized the system and thoroughly inspected all connections for leaks. No leaks were found, and the new water service is operating correctly. Cleaned the work area before leaving the job site.

Completed repair on a leaking pipe connected to the water heater. Identified the source of the leak, removed the damaged section, and installed new piping to restore a secure connection. System was pressurized and tested to ensure there are no further leaks. Water heater is now operating properly with no active issues.

Completed repair on a leaking pipe connected to the water heater. Identified the source of the leak, removed the damaged section, and installed new piping to restore a secure connection. System was pressurized and tested to ensure there are no further leaks. Water heater is now operating properly with no active issues.

Removed the existing toilet to inspect the flange and found it needed replacement. Installed a new toilet flange, secured it properly, and installed a new wax ring. Reset the toilet with new closet bolts, tightened and leveled the fixture, then reconnected the water supply. Flushed the toilet multiple times and thoroughly inspected for leaks around the base, flange, and supply connection. Verified proper operation and a secure seal before cleaning the work area and leaving the job site clean.

Electrician is installing a new 120v circuit

Installed a new water line to supply four new hose bibs. Turned the water on and thoroughly inspected all connections and fittings for leaks. No leaks were found, and all hose bibs are operating properly. Cleaned and organized the work area upon completion.

Giving a free electrical estimate for panel replacement

Responded to a service call for a main sewer line blockage causing slow drainage and backups. Performed a full main line auger service to clear the obstruction and restore proper flow through the system. Pulled the affected toilet to access the drain line and inspect for additional blockage. After clearing the line, installed a new wax ring, reset the toilet, secured bolts, and tested for proper flush and seal. Verified no leaks and confirmed normal drainage before completing the job.

Arrived on site to diagnose a leaking drain under the sink. Found a failed P-trap assembly with worn slip joint washers and improperly aligned PVC causing slow drainage and active leaks. Removed the damaged P-trap and existing PVC piping. Installed a new P-trap assembly and replaced affected PVC drain sections, ensuring proper slope, tight connections, and code-compliant alignment. Tested the system thoroughly after installation—no leaks present and drainage flowing properly. Customer was informed of the repair, shown the completed work, and advised on proper drain use to prevent future issues.