HVAC, Electrical & Plumbing in Adairsville, GA

Installed a split system and two mini split heads and condensers

Electrician installing ac disconnect

Arrived on site and replaced the PRV (Pressure Reducing Valve) and main house shut-off valve due to the PRV failing and the existing shut-off being improperly located. After installation, the T&P relief valve on the water heater continued discharging, so the T&P valve was replaced under warranty. After repairs were completed, the system was tested and operating properly. The meter box was excavated and inspected to verify the source of the water leak. Determined that there are no leaks on the homeowner’s side of the water service. The leak is located on the city side of the meter, and the municipality will need to perform the necessary repairs. Cleaned work area and verified proper system operation before departure.

Electrical Code Inspection: Performed a full residential electrical code inspection prior to a home sale. Inspected the panel, service entrance, branch circuits, and receptacle protection throughout the house. Identified outdated two-prong outlets in several rooms, missing GFCI protection in bathrooms and the garage, and an improperly grounded subpanel in the detached workshop. Documented all findings in a detailed report and reviewed required corrections with the homeowner to support the sale process.

Plumbing Repair: Arrived at a residence where the homeowner reported water pooling under the kitchen sink after running the dishwasher. Inspected the area under the cabinet and found a cracked drain elbow at the dishwasher discharge connection that had weakened from years of heat cycling. Removed the damaged fitting, installed a replacement drain assembly with properly sealed connections, and ran the dishwasher through a full wash cycle while monitoring for any additional leaks before closing up the cabinet.

Drain Cleaning: Dispatched to a residence experiencing slow drains in the master bathroom. Ran a camera inspection through the drain line and identified a significant soap scum and hair clog in the drain trap and further down the line. Performed mechanical cleaning to remove the blockage, flushed the line with water, and tested drainage flow at the sink, shower, and tub to confirm all fixtures were clearing properly.

AC Repair: Responded to a homeowner reporting the air conditioner was running constantly without reaching the thermostat setpoint. Inspected the outdoor unit and found the condenser coil heavily packed with cottonwood debris and pollen buildup, severely restricting heat transfer. Cleared the debris, rinsed the coil with a low-pressure wash, inspected the contactor and capacitor, and tested refrigerant pressures. Ran the system through a full cooling cycle and confirmed restored efficiency and steady indoor temperature drop.

installing a brand new toilet and replacing an outdated bathroom faucet. Ensured all connections were secure, leak-free, and up to code for long-term reliability. The new fixtures improve both water efficiency and overall bathroom functionality. If you?re in the Alpharetta area and need expert plumbing services like toilet installation, faucet replacement, or bathroom upgrades, we?ve got you covered with fast and reliable service.

Electrician installing new light fixture

Electrician installing new disconnects for hvac equipment also installing surge protection

Electrician replacing gfci receptacle

Electrician installing fan

Electrician is installing a new bath fan in bathroom remodel

Removed and replaced the existing HVAC system with a brand-new matching air handler and condenser. Completed installation according to manufacturer specifications, verified proper electrical and refrigerant connections, and performed a full system startup and operational check. Tested voltage readings, inspected refrigerant operation, and evaluated overall system condition and performance. Confirmed proper airflow, thermostat operation, and cooling functionality. System is operating properly and performing as designed at this time.

Arrived on site to provide a quote for installing a customer-supplied bathroom vanity and sink. Assessed the existing plumbing connections, drain location, and installation requirements. Discussed the scope of work with the homeowner and provided pricing for removal of the existing fixture (if needed), installation of the new vanity and sink, and reconnection of the water supply and drain lines. Answered all customer questions and left the area clean upon departure.

Arrived on site and replaced the customer-supplied washer box and shutoff valves. Picked up the necessary valves and completed the installation. Reconnected the water lines using PEX-to-copper connections and secured all fittings. Turned the water back on and thoroughly inspected the installation for leaks. No leaks were found, and all components are functioning properly. Cleaned the work area and removed all debris upon completion.

Performed a full-house plumbing inspection and well pump inspection. Checked all visible water lines, drain lines, fixtures, shut-off valves, and plumbing connections throughout the home for proper operation and signs of leaks. Inspected the well pump system, pressure tank, pressure switch, and associated components to verify proper functionality and system performance. Tested water pressure and confirmed the plumbing system was operating as intended. At the time of inspection, no active leaks or issues were found. Discussed findings with the homeowner and ensured all systems were functioning properly. Cleaned workspace upon completion.

Finished a full basement bathroom rough-in today for a local homeowner. Installed all necessary drain lines, water supply lines, and venting systems to prepare for future fixture installation including toilet, shower, and vanity. This phase is critical because it sets up the entire plumbing system behind the walls and under the slab before finishing work begins. ? ServiceTitan +1 Work included: ?? Layout and installation of drain & waste lines ?? Hot and cold water supply rough-in ?? Proper venting for code compliance ?? Prep for toilet, shower, and sink connections ?? Ensured correct slope and placement for long-term performance

Electrician completing electrical safety inspection

Electrician completing electrical estimate for panel replacement

Electricity giving free electrical estimate to install light

Electrician is installing a new car charger

Electrician is installing a new whip on ac system

Installed a brand-new well system for a residential customer, providing a reliable and efficient water supply. This included setting up the well pump, pressure tank, and all necessary connections to ensure proper water pressure and consistent performance. System was fully tested for functionality, leaks, and optimal operation.

Installed a new sewer ejector pump for a residential property, ensuring reliable wastewater removal from below-grade plumbing fixtures. Removed the old failing unit and upgraded to a high-performance system with proper check valve and venting. Tested the system for smooth operation and leak-free performance.