Electricians & Plumbers in Cedartown, GA

Came out and cut out a 5-foot section of 2-inch PVC drain line serving a grease trap and hand sink. Reassembled and secured the piping to meet current plumbing code and ensure proper drainage flow. Tested the system and confirmed everything is working correctly.

Came out and cleared a clogged commercial sink drain. Removed buildup and restored proper drainage to prevent backups and downtime. Customer’s sink is flowing normally again.

The original faucet had internal wear causing leaks and inconsistent water pressure. The existing supply lines and angle stops were also outdated and showing signs of corrosion, so they were upgraded to ensure long-term reliability and proper shut-off functionality. Upgrading angle stops and supply lines during a faucet replacement helps prevent future leaks and makes future servicing easier.

Completed a full basement plumbing rough-in today. Installed new drain lines, venting, and water supply lines for future bathroom and utility connections. Tied into the main sewer line and ensured proper slope and venting for code compliance. Pressure tested all water lines and verified secure fittings with no leaks. Basement is now fully prepped for fixtures including toilet, shower, and sink installation. Clean, organized layout for easy access and future finishing.

Technician arrived on site to address a busted copper water line. Isolated the water supply and removed a damaged 1-foot section of copper pipe. Installed new copper piping with proper fittings, soldered all connections, and restored water service. System was pressure tested to confirm there were no leaks. Area was cleaned up and repair completed successfully.

Arrived on site for plumbing service and found the existing P-trap leaking due to corrosion and worn slip-joint washers. Shut off water, removed the damaged P-trap, and installed a new properly sized P-trap assembly. Ensured correct alignment and slope for proper drainage, tightened all connections, and tested the drain for leaks. Drain is now flowing correctly with no leaks present. Customer was informed of the repair and proper drain usage.

Came out to the customer’s home and professionally installed two new braided supply lines. Ensured secure connections, proper fitment, and tested for leaks to restore reliable water flow. Another quality plumbing repair completed with attention to detail and long-lasting results.

Electrician is installing a new transfer switch

Finished the customer’s outdoor spigot repair and properly insulated the exposed piping to protect against leaks and freezing. Tested the spigot for proper operation and confirmed there are no leaks. Pipe insulation was installed to help prevent future freeze damage and improve long-term reliability. Another home protected with professional plumbing service.

Electrician is replacing a panel

Responded to a customer concerned about pipes freezing and faucets needing replacement. During the inspection, we found the home still had galvanized pipes from the meter throughout and a water heater dated 2008, which can contribute to low flow, corrosion issues, and efficiency loss. After providing a full assessment, we quoted a complete repipe, meter service upgrade, and new water heater installation. The customer approved the work, and we’re scheduled to return Friday to complete the project. If you’re experiencing freezing pipes, low water pressure, rusty water, or an aging water heater, we can help with professional repiping and plumbing upgrades.

Fixed drain under house

Plumbed in a condensate line on a tankless